
SGR Installation Instructions
PDF Installation Instructions
|
Selecting the Right Size
SGR for Your Motor
- Step 1: Measure shaft diameter at a point .125" (3mm)
from motor end bell.
- Step 2: To select the correct SGR part number, refer to
the SGR size chart provided.
NOTE: If you have a slinger or a shaft shoulder that is less than 0.375" (9.5mm), you will need the NEMA kit. See NEMA-IEC Shaft Grounding Kits in the Products Section.
* patented technology |
 |
|
Installation
For proper operation and optimum performance, install AEGIS™SGR
so that:
- The Conductive MicroFibers™ touch the shaft for effective
shaft grounding.
- The aluminum brush holder frame extends out from the motor
end bell approximately 0.28" (7 mm).
- The aluminum brush holder frame has even clearance around
the shaft.
- Slide SGR over motor shaft and position for even clearance
around the shaft.
- Drill two 0.25" deep holes into the motor end bell and
tap each with a 6-32 thread.
- Lock SGR in place by fastening brackets to motor end bell
using screws provided.
|
 |
 |
|