Q&A Series
Electrical Bearing Protection Q&A Part 32
This post is part 32 of our Electrical Bearing Protection questions and answers series.
Electrical Bearing Protection Q&A – Part 31 Detecting Damage
Questions and answers on detecting electrical bearing damage before bearing failure occur, by vibration analysis and shaft voltage measurement.
Electrical Bearing Protection Q&A – Part 30 Grounding Rings and Brushes
We answer your questions about the pros and cons of shaft grounding brushes vs shaft grounding rings.
Electrical Bearing Protection Q&A – Part 29 Grounding Straps
High frequency grounding straps: Why, when, and how to use them to protect VFD driven motor and equipment bearings.
Electrical Bearing Protection Q&A – Part 28
We answer questions on AEGIS conductive coatings: Our colloidal silver paint and conductive epoxy adhesive.
Electrical Bearing Protection Q&A – Part 27
Doubling down: Do you ever need two shaft grounding rings on a motor system? And what about motors with two insulated or ceramic bearings?
Electrical Bearing Protection Q&A – Part 26
This time, we talk about electrical discharge detectors, the quality of drive output, and output filters.
Electrical Bearing Protection Q&A – Part 25
As shaft grounding ring manufacturers, we answer questions about electric trains, submersible well pumps, and multistage pumps.
Electrical Bearing Protection Q&A – Part 24
We answer questions about VFD cable and safety cable, and what happens when motors are too far from their drives.








