AEGIS® Bearing Protection - Why Shaft Grounding?

Best Practices
Motors up to and including 100HP (75kW) - Low Voltage

In this section...
- Motors up to and including 100HP (75 kW) - Low Voltage
- Motors Greater than 100HP (75kW)
- Motors Where Both Bearings are Insulated
- Motors with Cylindrical Roller, Babbitt or Sleeve Bearings
- Vertical Solid Shaft Motors
- Vertical Hollow Shaft Motors
- DC Motors
- Notes on Grounding
- Colloidal Silver GHS SDS (pdf)
General recommendations: For induction motors either foot mounted, c-face or d-flange mounted motors with single row radial ball bearings on both ends of the motor. Motors may be installed either horizontally or vertically.
- Install one AEGIS® SGR Bearing Protection Ring on either the drive end or the non-drive end of the motor to discharge capacitive induced shaft voltage.
- AEGIS® SGR may be installed either internally or externally.
- Use AEGIS® Colloidal Silver Shaft Coating (PN# CS015) on motor shaft where fibers touch.
Application notes are intended as general guidance to assist with proper application of AEGIS® Bearing Protection Ring to protect motor bearings. All statements and technical information contained in the application notes are rendered in good faith. User must assume responsibility to determine suitability of the product for its intended use.